Connecting FrSky X4R SBUS Receiver to the Revolution (CC3D Revo) Flight Controller

Flight Controllers Receivers

26 May 2016

Connecting FrSky X4R SBUS Receiver to the Revolution (CC3D Revo) Flight Controller

antwerx 0 Comments

revo-ports

The Main Port (S.BUS)

The 4 pin main port is used as the Revolution‘s (Revo) serial port. You use this port to connect to your SBUS FrSky receiver. The pin-out of the cable is shown in the table below. You will most likely need to build the cable and the signal wire color can vary. It’s easy to do just pay attention to the pin-out and double check before powering up.

 

sbus cable

revo-x4r-sbus

 

RaceFlight Receiver Config:

Connect your Revo to RaceFlight and configure it to use the SBUSĀ  receiver.

sbus-RF-config-1

sbus-RF-config-2

1