Configurator

No matter how professional you are, sometimes mistakes are made.  Wiring a motor wires backwards or forgetting to reverse a motors direction sometimes happens. In RaceFlight One, it is an easy fix. First you’ll need to find out if you are running, or if you want to run with a “Reversed Prop Direction”. This option

To install Taranis OpenTX 2.2 and Add the RF.LUA, follow these steps – Before Proceeding make a backup of the models and settings Under Read/Write choose Backup Radio to a file. Go to https://raceflight.net/taranis/ and download the required firmware and files. Once installed, launch Opentx 2.2. Click on Settings and Settings again. Check Mark the option

The following guide will enable you to utilize your Team Black Sheep (TBS) SmartAudio enabled Video Transmitter (VTX) with RaceFlightOne (RF1).   Firstly, you will need to connect the VTX to your Revolt Flight Controller (This guide will work for both V1 and V2 Revolt flight controllers). Connect the VTX to a power source, if

Hey there, so here is a quick guide on what to do, when your windows pc configurator does not recognize your rf revolt fc with rf1 on it. For this tutorial there is also a video guide available: First you have to open your windows device manager.   In the device manger search for your

TPA can be adjusted and customized to “tame” aggressive pids during certain throttle positions. This can be especially handy if fighting Mid-throttle-oscillations, or vibrations during medium to high throtttle on HD video. To access the visual TPA in the GUI, navigate to the PID Tuning page in the latest GUI.  Next, select the “SHOW TPA”

Physical Connections 1) Solder S.Bus to TX1 Pad 2) Solder VCC to VCC Pad 3) Solder Ground to Ground Pad 4) Solder S.Port to RX3 5) Bridge VCC and 5V Pads for TX1 6) Bridge INV1 and TX1 Software Configuration 7) Run Detect Receiver step in RaceFlight One configuration software. Manual Configuration 8) Go to

Physical Connections 1) Solder S.Bus to TX1 Pad 2) Solder VCC to VCC Pad 3) Solder Ground to Ground Pad 4) Solder S.Port to RX3 5) Bridge VCC and 5V Pads for TX1 6) Bridge INV1 and TX1 Software Configuration 7) Run Detect Receiver step in RaceFlight One configuration software. Manual Configuration 8) Go to

All settings can be changed in the ESC tab of the GUI, but if you wish to use the Console to make changes to your ESC settings here is the list of commands. 1WIRE Commands (Must have battery plugged in and Props removed). Always “1wire save” after any changes. All commands are entered without quotations.