To install Taranis OpenTX 2.2 and Add the RF.LUA, follow these steps – Before Proceeding make a backup of the models and settings Under Read/Write choose Backup Radio to a file. Go to https://raceflight.net/taranis/ and download the required firmware and files. Once installed, launch Opentx 2.2. Click on Settings and Settings again. Check Mark the option

Physical Connections 1) Solder S.Bus to TX1 Pad 2) Solder VCC to VCC Pad 3) Solder Ground to Ground Pad 4) Solder S.Port to RX3 5) Bridge VCC and 5V Pads for TX1 6) Bridge INV1 and TX1 Software Configuration 7) Run Detect Receiver step in RaceFlight One configuration software. Manual Configuration 8) Go to

Physical Connections 1) Solder S.Bus to TX1 Pad 2) Solder VCC to VCC Pad 3) Solder Ground to Ground Pad 4) Solder S.Port to RX3 5) Bridge VCC and 5V Pads for TX1 6) Bridge INV1 and TX1 Software Configuration 7) Run Detect Receiver step in RaceFlight One configuration software. Manual Configuration 8) Go to

Spektrum bind support Spektrum bind with hardware bind plug support. The Spektrum bind code is actually enabled for the NAZE, NAZE32PRO, CJMCU, EUSTM32F103RC, SPARKY, CC3D, ALIENWIIF1, ALIENWIIF3 targets. Configure the bind code The following parameters can be used to enable and configure this in the related target.h file: SPEKTRUM_BIND Enables the Spektrum bind code BIND_PORT